Omron NT15S, Руководство по эксплуатации

Страница: 159 / 233

145
Standard Mode
Section 4-9
. . . . . . . . The user description stored in the FLASH con-
tains errors. This error may occur at the end of
a transmission, e.g. if the transmission is not
complete or after a terminal is switched on that
has a defective memory.
. . . . . . . . An attempt has been made to load a S3 file
which was intended for another terminal type.
When this error occurs, the correct type for this
terminal is displayed at the ‘XXXX’ position. Re-
compile using this selection in the programming
system.
. . . . . . . . An attempt has been made to load a S3 file
which was created for a larger mask memory.
The amount of memory space requested by the
S3 file and the memory available in the terminal
do not match. When this error occurs, the
memory size available in the terminal is speci-
fied, in kBytes, at the ‘XXX’ position. This value
must be specified in the programming system
when compiling.
. . . . . . . . An error message that should not occur, but
which exists. The operating system of the ter-
minal generates this error if proper operation is
no longer possible due to a lack of plausibility.
To be able to reconstruct the incident, we need
to know the code and subcode number as well
as the software versions of the operating sys-
tem and programming software. Do not hesitate
to call our hotline and we will help you.
. . . . . . . . If this error message is displayed, contact OM-
RON EUROPE B.V., Wegalaan 67-69,
NL-2132 JD Hoofddorp, Tel.: +31 23 56 81 300.
Before calling, make a note of the firmware and
hardware version. The operating system of the
operating terminal switches into an endless
loop to prevent damage to the device.
. . . . . . . . A checksum error has been detected when
checking the memory areas of the recipe data
sets. Either the battery or the RAM-memory is
defective.