Omron F3S-TGR-SB2-KXC, Руководство пользователя

Страница: 15 / 34

6-1 Setting the internal DIP-Switches 15
Section 6: Operating procedures
6-1 Setting the internal DIP-Switches
• Disconnect the SLC's power supply and remove the connector side of the transceiver, so that you can
access the two banks four-way dip-switches located there.
• Use a suitably sized screwdriver to set the dip-switches as per the required configuration according to
the following tables.
6-1-1 Selection of reset mode
!
ATTENTION
In every transceiver unit there are two separate dip-switch banks. The two banks must be set in the
same way to get a valid configuration.
Dip switches number 1 and 2, act on the partial muting configuration.
See "Partial muting configuration" chapter 7.3.
Single switch number 4 Reset
OFF Manual
ON Automatic (Default setting)
Single switch number 3 No function
OFF DEFAULT SETTING
ON NOT ALLOWED