![background image](http://html1.mh-extra.com/html/omron/f160-vision-sensor/f160-vision-sensor_operation-manual_741258044.webp)
35
Understanding Setting Operations
Section 2-3
CHECK
Results are not output via the parallel interface in Monitor Mode. Change to
Run Mode to output the results.
CHECK
Always save the condition settings to flash memory after they are set. The set-
tings will be cleared when the power is turned OFF if they are not saved
beforehand. (Refer to page 86.)
2-3-5
STEP 5: Entering Monitor Mode and Testing
Perform a test to confirm that inspections will be performed according to the
set conditions.
The measurement results can be referred to when adjusting the precision of
the judgement and the measurement time. The results are not output to the
parallel interface or serial interface and so the test can be performed with the
F160 only.
2-3-5-1
Performing Test Measurements
1.
Press the TRIG Key on the Console or turn ON the STEP signal.
One measurement will be executed.
Perform test
measurement
Help
Display
settings
ESC
SHIFT
+
ENT
SHIFT
+
SHIFT
+
1
Adjust judgement
precision
By region,
position compensation
Adjust
measurement time.
Judgement
Measurement time
2
3
Use the help function if the
inspection is not correct.
The type of screen display
(freeze or through) can be changed.
STEP
6
Содержание F160 Vision Sensor
