![background image](http://html1.mh-extra.com/html/omron/cpm2c/cpm2c_operation-manual_742519135.webp)
4-5
Section
*
4-5-5 Test Run in MONITOR Mode
Switch the CPM2C in MONITOR mode and check the operation of the program.
1, 2, 3...
1. Set the Programming Console’s mode switch to MONITOR mode.
RUN
MONITOR
PROGRAM
2. Press the CLR Key to bring up the initial display.
CLR
3. Force-set the start input bit (IR 00000) from the Programming Console to
start the program.
LD
MONTR
0
SET
The cursor in the lower left corner of the display indicates that the force set is
in progress. The bit will remain ON as long as the Set Key is held down.
4. The output indicator for output IR 01000 will flash ten times if the program is
operating correctly. The indicator should go OFF after ten one-second
flashes.
There is a mistake in the program if the output indicator doesn’t flash. In this
case, check the program and force set/reset bits to check operation.
Содержание CPM2C
