5. Applicable Devices and Support Software
5.2. Device Configuration
The hardware components to reproduce the connection procedure of this document are as
follows.
USB cable
Personal computer
(CX-One installed,
OS:Windows 7)
Ethernet cable
CJ2M-CPU12 +
CJ1W-NCF82
DS-Bus
E3NX-FA0
E3NW-ECT +
E3NX-FA0
E3NW-DS +
Manufacturer
Name
Model
Version
OMRON
Position Control Unit
CJ1W-NCF82
Ver.1.3
OMRON CPU
Unit
CJ2M-CPU12
Ver.2.0
OMRON
Power Supply Unit
CJ1W-PA202
OMRON CX-One
CXONE-AL[][]C-V4
/AL[][]D-V4
Ver.4.[][]
OMRON CX-Programmer
(Included in CX-One)
Ver.9.43
-
Personal computer
(OS: Windows7)
-
- USB
cable
-
OMRON
Ethernet cable (with industrial
Ethernet connector)
XS5W-T421-[]M[]-K
OMRON
Digital Sensor Communication
Unit
E3NW-ECT Ver.1.0
OMRON Distributed
Sensor
Unit E3NW-DS
Ver.1.0
OMRON Fiber
Amplifier
E3NX-FA0
Ver.1.0
- DS-Bus
communications
cable
-
Precautions for Correct Use
The connection line of EtherCAT communication cannot be shared with other Ethernet
networks.
Make sure to directly connect the PLC to the destination device with the Ethernet cable.
Please use the cable (double shielding with aluminum tape and braiding) of Category 5 or
higher, and use the shielded connector of Category 5 or higher.
Precautions for Correct Use
Update the CX-Programmer to the version specified in this section or higher version using the
auto update function.
If a version not specified in this section is used, the procedures described in Section 7 and
subsequent sections may not be applicable. In that case, use the equivalent procedures
described in the CX-Programmer Operation Manual (Cat. No. W466).
4
Содержание CJ1W-NC82
Страница 35: ...32...
Страница 36: ...2013 0911 P562 E1 01...