7. Connection Procedure
7.3. Setting Up the PLC
Set up the PLC.
7.3.1. Hardware Settings
Set the hardware switches on the Position Control Unit.
Precautions for Correct Use
Make sure that the power supply is OFF when you perform the setting up.
1
Make sure that the power supply
to the PLC is OFF.
*If the power supply is turned
ON, settings may not be
applicable as described in the
following procedure.
2
Check the hardware switches on
the front panel of the Position
Control Unit by referring to the
right figure.
3
Set the Unit No. Switch to 0.
4
Connect each PLC unit in order
from the Power Supply Unit,
CPU Unit, Position Control Unit
and End Cover.
Connect the Ethernet cable to
the Position Control Unit and
connect the USB cable to the
CPU Unit.
After connecting, turn ON the
power supply to the PLC.
Indicators
Show the operating status of the Position Control Unit.
Unit Number Switch
Set the unit number of the Position Control Unit.
EtherCAT Communications Connector
Connect to the EtherCAT Communications Cable.
Indicators and Display
Show the EtherCAT communications status.
Ethernet
cable
End Cover
Position
Control Unit
Power
Supply Unit
CJ-series
CPU Unit
USB Cable
13
Содержание CJ1W-NC82
Страница 35: ...32...
Страница 36: ...2013 0911 P562 E1 01...