49
Connecting to the Network
Section 3-3
Selecting SYSMAC CS/CJ
IF Port
Perform steps 1 through 3 of the above procedure.
4.
The Setup Interface Dialog Box will appear if a SYSMAC CS/CJ IF Port is
specified.
Set the following items.
Interface
Select the interface from the following settings for the serial communications
mode at the serial communications port of the CS/CJ-series PLC.
• Host Link
• Toolbus
Network Address
Input the network address of the DeviceNet Unit to be connected. Input if
crossing networks past the serial communications of the CS/CJ-series CPU
Unit. If not crossing networks, input 0.
Node Address
Input the node address of the DeviceNet Unit to be connected. Input if cross-
ing networks past the serial communications of the CS/CJ-series CPU Unit. If
not crossing networks, input 0.
Unit No.
Input the unit number within the following range for the CS1W-DRM21
DeviceNet Unit as a CPU Bus Unit. The unit number must be the same as that
set with the thumbwheel switches on the front panel of the CS1W-DRM21.
• 0 to 15
COM Port
Select the COM port of the computer running the Configurator within the fol-
lowing range.
• Select from the list of usable COM ports.
Содержание 3G8E2-DRM21-EV1
