11038895_V_1_0.DOC
23/29
8. BASS- CONTROL
Used to increase or lower the LOWs of the master signal.
9. LEVEL CONTROL
With the level control, you can adjust the master level.
10. AUX LEVEL
-
CONTROL
11. REVERB MASTER
The effect intensity can be adjusted via the Reverb-master.
12. ON LED
13. POWER SWITCH
Press this button to start operation.
4.3 Back panel
MAIN
IN
LINE
OUT
AC IN
SPEAKER OUT
A
B
www.omnitronic.com
Type:
OMNITRONIC COMBO-70
Power supply:
115/230 V AC, 50/60 Hz
Power consumption: 550 W
Fuse 230 V:
T 3 A, 250 V
Fuse 115 V:
T 6 A, 250 V
~
CAUTION
!
Read user manual before use. Keep away from moisture! Disconnect from mains
before changing fuse. Replace the fuse only with the same type and rating.
Never open the housing! There are no serviceable parts inside the device.
Maintenance and service operations only by authorized dealers.
Vor Gebrauch Anleitung lesen. Gerät vor Feuchtigkeit schützen! Vor Sicherungswechsel
vom Netz trennen! Nur Sicherungen mit gleichen Leistungswerten einsetzen. Niemals
das Gerät öffnen! Im Geräteinnern befinden sich keine zu wartenden Teile.
Wartungs- und Servicearbeiten nur durch autorisierten Fachhandel!
Lire le mode d'emploi avant l'utilisation. Ne pas exposer à l'humidité. Débrancher avant
de remplacer le fusible. Utiliser un fusible de rechange de même type. Ne jamais ouvrir
le boîtier! L'intérieur de l'appareil ne contient pas de parties nécessitant
un entretien. L'entretien et les réparations seulement par un revendeur autorisé!
EFFECT
AUX IN
COMBO-70
14
15
16 17 18
13
13. FUSE HOLDER
Only replace the fuse when the device is disconnected from mains. Only use fuses of the same rating and
power.
14. AC INPUT-SOCKET
Used to plug the power cord in.
15.SPEAKER-OUTPUT SOCKETS
For connecting two speakers.
16. MAIN IN
Here, you can connect the line-signals via balanced or unbalanced jack plugs.
17. LINE OUT
Output sockets for connecting further active systems.
18. AUX IN
Here, you can connect the line-signals via Cinch-plugs.
4.4 Connections
Install the device on a solid, plane, anti-slip, vibration-free, oscilation-free and fire-resistant surface.
Make sure that the power switch is set to OFF. Before you connect the devices, all units have to be switched
off.
The inputs of this PA-system are to be directly connected with the outputs of your audio source. Solo
entertainers can also directly connect their keyboard with the stereo channels' RCA-sockets. Further
microphones have to be connected with the Mic-sockets. Never connect any input with an amplifier output!