OmniSTAR 5220HP, Руководство пользователя

Страница: 74 / 83

OmniSTAR 5220HP User Manual
Issue 1.32 12/2010
74
Appendix E
Updating the 5220HP firmware
In order to update the 5220HP firmware, an MS-Windows compatible
computer (either desktop or laptop) and the RightArm program are required.
The 5220HP has to be connected to a communication port of the computer
and has to be switched on. The update process does not require reception of
either GPS or OmniSTAR satellite signals. During the update process, do not
switch off either the computer or the 5220HP receiver and do not disconnect
the 5220HP from the computer.
Instructions for loading the firmware for the 5220HP :
1. Connect 5220HP to a COM port on your computer (please set the 5220HP
baud-rate to 19200 before proceeding – you must use 19200 to load firmware).
2. Run the program RightArm.exe (version 3.32) by double clicking it.
3. Click Receiver -> Connect.
4. Select the appropriate COM port on your computer and select 19200 for the
baud- rate in RightArm and set the baud rate of your 5220HP to 19200 baud.
5. Click Receiver -> Program.
6. Under Program Type, select Application 1.
7. Click Select File button and browse to the files that you unzipped.
8. Select the file: EclipseOmniHP_v49L.bin
9. Make sure the ‘Activate Loader’ box is checked.
10. Power down and then power up the receiver.
11. The status box should say “Activate Loader Received—Receiver is in
Loader Mode” and the Activate Loader box should become unchecked.
12. Click the ‘Erase and Program’ button.
13. Once programming is complete, the Status box should say “Programming
Done”.
14. Close the RightArm program. Make sure to cycle the power on the unit
before use.
Updating the firmware may (partly) erase existing OmniSTAR subscription
information from receiver memory. It is therefore recommended to check the
subscription end dates with $JI (see page 38) after each firmware upgrade.