[email protected] | Installation manual Omnicomm 2.0 terminals v2.2
7
.16 | 23
4) Firmly attach the adapter of push-to-talk switch on the surface using self-driving screws (Figure 22).
5) Connect push-to-talk switch connector with the connector of push-to-talk switch adapter (Figure 23).
FIGURE 20
FIGURE 21
FIGURE 22
FIGURE 23
6.8 INSTALLATION OF THE IBUTTON READER FOR THE OMNICOMM PROFI 2.0
AND OMNICOMM PROFI 2.0 WIFI TERMINAL
The iButton reader must be installed on the front panel of the vehicle or in the cable feed-through on the
front of the vehicle.
6) At the installation site, drill a Ø9 mm hole.
7) Insert the iButton reader into the prepared hole.
8) Install the ring and the locking washer, as shown in Figure 24.
