Omnia MN-RCV3, Справочное и монтажное руководство

Страница: 8 / 28

6 Reference & Installation Manual
3.0 PROGRAMMING
To successfully install an Omnia wireless system to your Digiplex or DigiplexNE
system, ensure that the following steps are completed:
1. Install the Omnia Receiver. Connect the Omnia Receiver to the Digiplex or
DigiplexNE control panel and power up.
2. Assign the remote controls if necessary.
3. Assign the transmitters (door contacts and motion detectors), and program their
zones.
4. Install the transmitters. Insert the batteries, and close the transmitter cover.
5. Wait for the control panel to be in “ready” mode. The status light on the keypad
will be green when the control panel is ready.
6. In order to ensure proper synchronization between the transmitters and receiver,
open and close the transmitters’ covers and zones.
3.1 PROGRAMMING METHODS
Programming of the OMN-RCV3 is accomplished using a variety of methods.
3.1.1 F
EATURE
S
ELECT
P
ROGRAMMING
(U
SING A
K
EYPAD
)
Sections are programmed through the control panel’s Module Programming
Mode using the Feature Select Method, where each number from 1 to 8
corresponds to a specific feature or option. Set these options by turning the
number corresponding to the feature ON or OFF. The option is considered ON
when the number appears within the brackets on the LCD keypad or when the
number is illuminated on an LED Keypad. Press the number button again to
remove the digit, thereby disabling (turning OFF) the option. Press the buttons
as many times as you need to select the desired options and then press
[
ENTER
] to save.
3.1.2 W
IN
L
OAD
With the WinLoad Security System Management Software, the control panels,
modules and keypads can be programmed remotely through a modem or on-
site at 19,200 baud or 38,400 baud (DGP-NE96 only) with a 306 Adapter. For
details refer to the Digiplex or DigiplexNE Reference & Installation Manual.