Omnia MN-RCV3, Справочное и монтажное руководство

Страница: 11 / 28

Omnia 9
When one section is programmed, the keypad will automatically
switch to the next section.
3.3.5 D
ELETING THE
T
RANSMITTERS
A
SSIGNED TO THE
R
ECEIVER
SECTIONS
[101]
TO
[116]
The transmitters assigned in sections [101] to [116] can also be deleted in the
same sections.
3.3.6 A
SSIGNING THE
T
RANSMITTERS TO
Z
ONES IN THE
C
ONTROL
P
ANEL
The detectors and door contacts must be assigned to zones in the control
panel. The allocated zones must then be programmed. For more information
on assigning and programming zones, refer to the Digiplex or DigiplexNE
Reference & Installation Manual.
3.4 VIEWING THE SIGNAL STRENGTH OF TRANSMITTERS
SECTIONS
[601]
TO
[616]
Once the detectors and/or door contacts have been installed and assigned to the
Receiver Module, the actual signal strength of each device can be verified in
sections [601] to [616]. Each section represents the signal strength viewer for a
specific device. For example, section [601] is the viewer for the device in section
[101] and section [616] is the viewer for the device in section [116].
How to delete the assigned transmitters.
In step 5 in Figure 3.3 on page 7:
1. Enter the desired [
SECTION NUMBER
] (101 to 116).
2. Enter 6 zeros (000000) in place of the 6-digit serial number.