5
Accessing the Web Interface
TICRO 100
automatically powers up after supply voltage is applied. The green LED S1 lights up and
the red LED S2 is off when the device is ready for operation.
TICRO 100
can be configured and controlled completely via the Web Interface using a computer.
Under normal circumstances, no manual intervention at the device itself will be required.
5.1
System requirements
Your computer must fulfill the following requirements to access the
TICRO 100
Web Interface:
•
OMICRON
Device Link
installed (see chapter "OMICRON Device Link" of the TICRO 100 User
Manual).
OMICRON
Device Link
is always required for the initial access to
TICRO 100
. If a static
IP address is assigned to
TICRO 100
, the device can be accessed any time and from
any computer using this IP address.
•
Web browser installed (Microsoft Edge, Mozilla Firefox 20 or higher, or Google Chrome version 31
or higher).
•
For access via Ethernet network only:
Network port configured for operation in the network
TICRO 100
is connected to.
•
For access via USB only:
USB 2.0 port available. While accessing
TICRO 100
via USB, the computer must not be
connected to the same Ethernet network
TICRO 100
is connected to!
If you are accessing
TICRO 100
from a Mac or Linux operating system supporting zeroconf,
you can access the Web Interface of
TICRO 100
by entering
http://<hostname>.local
to the
address bar of your web browser. The default hostname is the device serial number. The
serial number is available on the type plate on the bottom side of
TICRO 100
(labeled
"SerNo").
5.2
Accessing the TICRO 100 Web Interface
OMICRON
Device Link
is required for initial access to
TICRO 100
. If you know the IP
address of
TICRO 100
, it is alternatively also possible to access the device from a web
browser using its IP address (without using OMICRON
Device Link
).
Proceed as follows to access the
TICRO 100
Web Interface using OMICRON
Device Link
:
1. Connect your computer to the network or to the USB port of
TICRO 100
.
(Please note: Access via the USB port may possibly be disabled in the
TICRO 100
configuration
(see
Access Restrictions
tab in section "Security configuration page" of the TICRO 100 User
Manual)).
2. Supply your
TICRO 100
TICRO 100 Quick Start Guide
18
OMICRON
