10 |
P a g e
Power Button
The Power Button is located on the top of the XW Transmitter. It allows for powering on and powering off the device.
Figure 10
When you press the power button, the blue LED light will illuminate immediately.
•
Turn On:
Press and Release the external ON/OFF button to turn on the device. The blue light will illuminate.
•
Turn Off:
Hold the external ON/OFF button for longer than 7 seconds until you see the blue light is turned off, then
release the button.
•
Reset
: When the device is ON, push and release the ON/OFF button to reset the device. The blue light will blink.
Configuring your ZW-REC
Ensure your ZW-REC is setup, running, and connected to the computer running SYNC. SYNC will pull the IP Address, Network
Mask, Gateway, and Network ID from your ZW-REC.
Step 1:
Turn on your PC and ensure that SYNC
is downloaded, installed, and running.
Step 2:
Plug in your ZW-REC to your computer with a
Micro USB cable
.
Note:
For a complete guide on how to setup your
ZW-REC, refer to the Quick Start Guide available
on the Omega website.
Important:
The latest version of the ZW-REC firmware is required. Please ensure you are using the latest version by
visiting the Omega website.
Connecting your XW Transmitter
Step 1:
Ensure the XW Transmitter is powered on.
Step 2:
Connect the XW Transmitter to your computer
via Micro USB cable. See
Figure 12
.
Note:
SYNC will auto-detect your XW Transmitter. If the
auto-detect feature fails, please click
in SYNC to
search for connected devices, or refer to the section titled
Connecting to SYNC – Manual
.
Figure 11
Figure 12
