![background image](http://html1.mh-extra.com/html/omega/mds-dtm-rtd-series/mds-dtm-rtd-series_user-manual_4512776016.webp)
Installation, Mounting & Wiring
3
3-5
3.8 Rear Panel (M12 Input, Analog Output, Alarm Output)
Figure 3-8. Rear Panel Connections (M12 Input, Analog Output, Alarm Output)
3.9 Battery Installation/Replacement
To install or replace the battery in your End Device you must first remove the
cap on the Battery Holder located on the Rear Panel. This will allow you access
to the batteries.
Figure 3-9. Battery Installation/ Replacement
Lithium batteries may get hot, explode or ignite and cause serious injury if
exposed to abusive conditions. Be sure to follow the safety warnings listed below:
• Do not use a different battery other than what is specified in this manual or
product data sheet.
• Do not discharge the battery using any device except your meter.
• Do not place the battery in fire or heat the battery.
• Do not store batteries with other hazardous or combustible materials.
• Do not install the battery backwards so the polarity is reversed.
OMEGA ENGINEERING, INC.
STAMFORD, CT. 06907-0047
MDS-DTM-R
TD SERIES METER
CAUTION: DISPOSE OF BATTERY PROPERLY
SEE MANUAL FOR INSTRUCTIONS
BATTERY: 2x D-CELL, 1.8 Vdc MAX
12 - 24 Vdc
FUSE: F1A, 250V
ANTENNA
www.omega.com
e-mail: [email protected]
INPUT
1 2 3
ANALOG OUTPUT
1 2 3
ALARM OUTPUT
USB PORT
INST
ALLA
TION CA
TEGOR
Y
II
+
–
–
+
www.DataSheet.net/
Datasheet pdf - http://www.DataSheet4U.co.kr/