Omega Excalibur AL-1920-EDP, Руководство по эксплуатации

Страница: 6 / 28

6
Controller & Transmitter Functions (cont’d)
TRUnK RELEASE / CHAnnEL 2:
Press and hold the “TRUNK”
icon for 3 seconds�
THE SYSTEM WILL DISARM AND THE TRUNK WILL •
OPEN�
UPON RECEIVINg CONFIRMATION FROM YOUR •
SYSTEM, THE CONTROLLER WILL PLAY THE TRUNK
RELEASE ANIMATION AND VOICE ALERT
(1-way transmitter: press anD holD the trunk
button for 3 seConDs)
REmOTE START: Press and release the “ ” icon twice within 5
seconds� (see user feature #21 for additional options)
THE PARKINg LIgHTS WILL FLASH ONCE AND THE •
STATUS LIgHT WILL FLASH RAPID gREEN�
THE SYSTEM WILL TURN ON THE IgNITIONS AND •
PROCEED TO START THE ENgINE�
ONCE THE ENgINE IS RUNNINg, THE PARKINg •
LIgHTS WILL TURN ON AND STAY ON AND THE STATUS
LIgHTS WILL FLASH SLOW gREEN�
UPON RECEIVINg CONFIRMATION FROM YOUR •
SYSTEM, THE CONTROLLER WILL PLAY THE REMOTE
START ANIMATION AND VOICE ALERT�
THE CLOCK WILL CHANgE TO 0:00 TO START THE •
REMOTE START TIMER� IT WILL TIME HOW LONg THE
ENgINE RUNS IN MINUTES & HOURS�
( 1-way transmitter: press the start button
twiCe in 5 seConDs)
*
If the engine stalls, the system will make up to 3 more attempts� •
Each time you park your vehicle, set the climate controls to give you the de- •
sired interior temperature when you use the remote start�
The engine will run for the preset run time (see user feature #1)�
Run Time Extender • : Press the “ ” icon one time while in remote start mode
to restart the engine run timer� The timer on the controller will restart at “0:00”�
nOTE: This can only be used once per remote start cycle. The controller will also give you
“run time expiration” warning (2 chirps) 1 minute before the remote start cycle ends.
If you decide not to drive your vehicle, you can turn off the remote start using •
the same method to turn it on (Default = press “start” twice in 5 seconds)
nOTE: If user feature #21 is programmed for 1 press, the 1st press = Run Time Extender so
an additional press is required.
Upon entering the vehicle during remote start mode, turn the ignition key to •
the “ON/RUN” position ( nOT START!! )� When you press the brake pedal, the
remote start will turn off allowing the ignition key to take over�
*
x2