OPERATING
with Optional Flywheel Adapter
Install the flywheel adapter
1. Keep jack in lowest position. Remove the release
pin, then remove the spline sleeve and adapter shaft.
2. Install the flywheel adapter assembly, then secure
with the quick release pin.
Note:
Flywheel adapter assembly includes flywheel
adapter, a shorter adapter shaft, and a C-clip (Fig. 3).
Use the shorter adapter shaft on flywheel adapter only.
Removing a Flywheel
1. Remove all the flywheel attaching bolts (flywheel to
crankshaft bolts) except for the three bolts pointed
in Figure 4.
2. Install the flywheel adapter as shown in Fig. 4. Close
the release valve knob fully. Pump the handle to raise
the lifting arm and align the flywheel adapter to the
flywheel using the tilt adjustment bolt.
3. Center the flywheel adapter to the flywheel and bolt
the adapter to the flywheel. Leave room to access
the remaining three flywheel attaching bolts retained
on the flywheel.
4. Ensure the release valve knob of the jack is closed
tightly before removing the last three flywheel
attaching bolts.
4
Figure 3 - Flywheel adapter assembly components
Adapter Shaft
C-clip
Flywheel Adapter
5. Back the jack and flywheel away from the engine
and slowly lower the flywheel.
6. Then while supporting the flywheel, remove the
flywheel from the adapter.
Loading and Unloading a Flywheel from the Jack
1. To load or unload a flywheel from the jack, be sure
the jack is in lowest position.
2. While supporting the flywheel, remove the flywheel
from the adapter.
Installing a Flywheel
1. Close release valve knob, pump the handle and
raise the flywheel into position shown in Figure 4 for
installation. Adjust the flywheel using tilt adjustment
bolt to align the flywheel with the crankshaft.
2. Install and tighten the attaching bolts.
Note:
Tighten the flywheel attaching bolts gradually.
Each bolt should be tightened to the specified torque
in a crisscross method. Refer to vehicle service manual
for the tightening sequence and torque.
Figure 4 - Flywheel Adapter Operational Illustration
Adapter Shaft
Head Plate
Release Pin
Tilt Adjustment Bolt
Flywheel
Adapter
Front View
Three attaching bolts
retained on flywheel
before securing the
adapter to flywheel.
Lifting Arm
Pump Handle
Release Knob
Flywheel
Flywheel
Flywheel
Adapter