Omcan VP-CN-9200, Инструкция по эксплуатации

Страница: 11 / 20

11
Troubleshooting
Particles (Powder) or liquids have been
in the sealing area of the bag.
The open end of the bag must be completely clean and dry for
making a good seal. Cut off the upper rim of the bag and wipe
clean the top of the bag. Perhaps, remove some material from the
bag to leave some more free space on the top of the bag.
Foods with high liquid contents prevent
the bag from being sealed properly,
because high amounts of liquid are
sucked in during evacuation.
Cut off the upper rim of the bag and wipe clean the top of the bag.
Perhaps, remove some material from the bag to leave some more
free space on the top of the bag.
Partially freeze foods with excess liquids prior to vacuum sealing. If
you can’t, place a folded paper towel between the food and the top
of the bag, but below seal area. Leave the paper towel in the bag
to absorb excess liquid. This way, during evacuation, liquids will not
be sucked out so easily.
YOU CANNOT SWITCH ON THE APPLIANCE
Possible Reasons Possible Solutions
The appliance is not live. Ensure that the power cable is undamaged and plugged in correctly
at the power supply and at the power socket of the appliance. By
connecting a lamp, ensure that the mains power outlet is live.
Ensure that you have turn on the power switch, which is located
above the power socket.
The overheat protection is active. Unplug the appliance and wait for at least 20 minutes. Then try
again.
THE BAG MELTS OR IS RIPPED AT THE SEAL
Possible Reasons Possible Solutions
You have used improper bags. Only use bags suitable for vacuum sealers.
The heating bar is too hot during the
sealing process.
Allow the appliance to cool for 20 seconds between uses.
The seal time is too high. Reduce the seal time.
The appliance may be overheated. Leave the appliance cool down for at least 20 minutes with the lid
open. After each sealing process, wait at least 20 seconds before
sealing the next bag.
THE CANISTER IS NOT VACUUMED (FUNCTION VACUUM CANISTER)
Possible Reasons Possible Solutions
The vacuum hose is not connected
properly.
Ensure that the correct end of the vacuum hose is inserted properly
into the vacuum outlet of the appliance.
Ensure that the connection of the vacuum hose on the vacuum port
of the canister lid is airtight.
The vacuum hose is damaged. Contact your vendor for replacement.