Omcan MG-IT-0012, Инструкция по эксплуатации

Страница: 6 / 16

6
Installation
MAIN CHARACTERISTICS OF THE TOOLS WHICH CAN BE INSTALLED IN THE MACHINE
The machine is supplied with a plate each hole of which has a diameter of 6/8 mm in order to comply with rule
UNI EN 294 paragraph 4.5 (access through openings). To perform different processing operations, however,
it is possible to fit in plates with holes having a smaller diameter compared with the plate supplied by the
manufacturing company without modifying the functional characteristics of the machine. If a supply is needed,
please refer to TAB. A.
Omcan shall not be held responsible for any accidents deriving from the use, on the “ELECTRIC MEAT
MINCER”, of plates with holes having a diameter of more than 8 mm. which are easily available on the
market because they can be used on meat mincer operated by hand. In fact, if these plates are used
without taking specific protecting measures in order to bring the safety standards within the range
required by law, the safety parameters requested by the above mentioned rules are no longer complied
with.
SETTING UP THE MACHINE
• Fit the body into its seat in the motor assembly after partially unscrewing the hand wheel. Make sure that
the body has been fitted with the meat-supply opening turned up and that it has been driven into its seat
up to the end; lock into place by turning the hand wheel to the end without forcing the locking position too
much.
• If the body has been properly assembled, it cannot be taken out or revolve in its seat.
• Fit horizontally the screw in the body on the side of the grooved shaft driving it on the bush (a component
placed inside the body).
• At this stage, if necessary, slightly rotate the screw so that the insertion of the clutch into the motor drive
will be made easier.
Technical Specifications
Model MG-IT-0012
Maximum Power 1 HP / 746 W
Rated Power 0.4 HP / 300 W
RPM 100
Electrical 110V / 60Hz / 1
Weight 27 lbs. / 12 kgs.
Packaging Weight 29 lbs. / 13 kgs.
Dimensions 19.3” x 9.5” x 15.4” / 490 x 241 x 390mm
Packaging Dimensions 26” x 20” x 20” / 660 x 508 x 508mm
Item Number 41419