![background image](http://html2.mh-extra.com/html/omcan/fp-it-0006/fp-it-0006_instruction-manual_5153230014.webp)
14
Maintenance
INTRODUCTION
Good maintenance and proper use are essential requirements to ensure the efficiency and safety of the mixer
To ensure regular and constant operation and to avoid invalidation of the warranty, machine components must
be replaced only with original spare parts.
CHECKS CARRIED OUT AT OUR MANUFACTURING PLANT
The manufacturer has conducted a number of tests on the machine in your possession, in order to ensure
correct commissioning and include the necessary adjustments. In particular, the manufacturer has performed
the following checks:
bEFORE COMMISSIONING:
• Control of the operating voltage of the machine: the voltage must be the same requested by the buyer.
•
Checking for the presence of all the warning signs/labels and the rating plate with the technical
specifications and serial number.
•
Checking of tightness of all bolts and nuts.
•
Compliance of the machine to the applicable regulations/standards and to the instructions provided in this
manual.
WITH THE MACHINE IN OPERATION:
• Checking of the efficiency of the safety devices and guard; the machine must stop when the operator
opens the grille.
•
General operating control.
•
Execution of repeated tests in order to verify the machine’s set-up, according to the type of work it will be
used for.
CHECKS AND INSPECTIONS TO bE CARRIED OUT DURING INSTALLATION
To make sure that the machine has not been damaged during transport or installation, make sure that you
diligently perform the checks and inspections listed below:
bEFORE COMMISSIONING:
• Check that the voltage corresponds to the value shown on the machine identification plate.
•
Check for the presence and integrity of the warning and danger signs/labels.
•
Check the integrity of the power cable.
•
Check that the safety devices, such as magnetic sensors, are intact.
CHECKS WITH MACHINE IN OPERATION:
• Check the efficiency of the safety guards and devices. These may have been damaged or impaired during
transport.
•
Perform a few test runs with products of the same size of the material you will then process.
ROUTINE CHECKS
To maintain the features and reliability of your machine consistent over time, you should perform additional
Содержание FP-IT-0006
