Omcan BL-IT-0075-VT, Инструкция по эксплуатации

Страница: 11 / 28

11
Maintenance
ENGINE’S BODY
1. Unplug the feeding cable from the net to insulate the machine from the electrical feeding completely (Fig.
61).
2. Remove possible product splashes that deposited on the machine’s body with a wet sponge and dry
immediately with a cloth.
3. Check that no residual from the work nor liquid did not enter the cone fixing the tools and in such case
remove them with a cloth. Reuse the blender to another operation.
4. Position the engine’s body on the special wall bearing.
EXTRA CLEANING
GENERAL INFORMATION (FIG. 63)
• Such operation is an exclusive requirement of this machine.
• This operation is to be carried out only in case of poor cleaning tasks executed by previous operators or in
case unpleasant smells, internal encrustations, etc. can be perceived.
• This operation is quite delicate and particular even if simple and could compromise the functioning of the
machine. Therefore, it is recommended to have it carried out only by responsible and expert members of
staff.
ATTENTION: this operation exposes the operator to risks due to the manipulation of knives and
sharp parts. Hence, it is recommended to use protective gloves and to be extremely careful all the
time.
Disassembly of the shaft (Fig. 64)
1. Detach the shaft from the engine’s body and position it on a surface with the knives on the right side.
2. Predispose the tools (a-b-c), grip the tool (c) with the left hand and insert it in the dragging device inside the
shaft.
ATTENTION: using a key (3), unscrew anticlockwise till the blade group is removed.
3. Grip the tool with the right hand (a) and insert it in the lower support matching the reference. Unscrew
everything clockwise till removal of the lower support. Pay attention not to lose the sealing gasket (o-ring)
from the lower support.
4. Remove the inner shaft from the main shaft pushing it towards the tool (c).
5. Proceed to clean the single pieces with a dump cloth and some dish detergent, keeping in mind that the
bearings must not come into contact with liquids.
6. In case of encrustation, insist with the cloth. Do not use abrasives, pointy or sharp tools.
7. Re-assemble everything the opposite way.
ATTENTION: fix firmly the knife or this could detach itself during the operating stage.
Check the state of the gaskets 1 and 2. In any other case, call customer service for supplies and replacements.
MAINTENANCE
GENERAL INFORMATION
Before carrying out any maintenance task, it is recommended to unplug the feeding cable from the net to
insulate the machine from the rest of the plant completely.