Omcan BL-IT-0075-VT, Инструкция по эксплуатации

Страница: 9 / 28

9
Installation and Operation
MACHINE’S USE
ATTENTION
• Check that the machine is perfectly dry and that there is no dirt or humidity from previous uses or washes
(Fig. 43).
• Check that the shaft or the whip have not residual encrustations from previous uses.
• Before using it, ensure that the shaft and the whip are fixed to the engine’s body properly (Fig. 44).
• Check that in the previous uses the components or protections have not been removed.
• Check the state of the feeding cable that could have been worn out by the different knives and tools in the
kitchen. In this case, please contact customer service immediately.
There are three shafts of different length. If available, always use the shaft whose length prevents the
immersion of the engine of the product. Assemble the tools as per chapter 5. Grip the dipping blender by the
handle with one hand and grip the lowest part above the maximum level (marked on the shaft Fig. 45) with the
other one. Never grip the engine’s body in a way to obstruct the vent’s opening (Fig. 46). Posture correctly and
comfortably in order to work safely and easily. It is FORBIDDEN to use the immersion blender with pots placed
on burners, heating plates or on excessively high worktops (Fig. 47). Insert the dipping blender with the tool
slightly inclined to the maximum height marked on the working shaft. As for the whip, the product must always
remain at 2-3 cm from the whip’s body (Fig. 45).
Switch the machine and move the shaft and the whip towards the inner part of the container with slow but
regular revolving movements. It is recommended not to touch the container’s walls with the whips. As for
the shaft, alternate the revolution even in the movements from the top to the bottom to ease the entry of the
products to be whisk in the operating bell (Fig. 48). Work till the desired consistency is obtained, once finished
using it, switch the machine off.
ATTENTION: do not use the machine in free air and to avoid any risk of physical or mechanical
damage, never extract the tool from the product while still rotating (Fig. 49).
ATTENTION: as a result of the centrifuge effect, the liquid tends to rotate and to higher its level closer
to the border of the container, when the blender is functioning, hence never fill the container over 2/3
of its capacity (Fig. 48).
Never carry out work cycles for over 10 minutes and keep the blender switched off anyway for at least 10
minutes between a work cycle and the next (Fig. 51).
At the end of the working cycle, remove the machine from the working container and proceed immediately to
the cleaning of the tool. Never leave the machine unattended inside the container.