Omcan 43466, Инструкция по эксплуатации

Страница: 9 / 20

9
Operation
Maintenance
• Open the lid, and clean the inside hopper with dry cloth. Then carefully press on the flat surface of the
blade to make sure it is well fixed.
NOTE: It is extremely important that:
• WHEN CHECKING THE BLADE BE SURE THE UNIT IS LOW ENOUGH SO YOU MAY SEE INSIDE THE
HOPPER. DO NOT REACH IN WITHOUT FULL VISIBILITY OF THE LOCATION OF THE BLADE.
• DO NOT TOUCH THE END OF THE BLADE. IT IS SHARP AND MAY RESULT IN SERIOUS INJURY.
• Before plug the power cord in please examine the cord, plug if there is any damage or hidden danger of
leakage, or the contact is good. The unit has power on demand and is always off.
• Open the lid and put in defined amount of ice cubes, then cover it. Kindly take note that the maximum of ice
cubes in the hopper should be at least 5cm deep from the top surface of the machine.
• Close the lid and Switch it on by the power switch on the side of the machine. For your safety, shaving will
not start with lid open.
• You can adjust the size of ice flake from big to small by turning the adjusting knob.
• For its full utilization and optimum efficiency, it is suggested that the diameter of the ice cubes should be
around 1”. Big ice should be hammered into small pieces to make sure the size is suitable.
IMPORTANT: DO NOT HAMMER ICE INSIDE OF THE HOPPER OR YOU MAY DAMAGE THE
EQUIPMENT.
• If ice is stuck together in the hopper and will not separate with a gentle tap, carefully remove the ice in
order to break it apart for standard operation.
WARNING
Before proceeding with cleaning and maintenance operations, make sure the power line of the unit is
disconnected.
CLEANING
• Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Always use mild soapy water to clean the interior of the appliance. Rinse thoroughly with fresh water and
wipe dry after cleaning.
SANITIZING SOLUTION
To sanitize the unit, prepare a sanitizing solution made with ½ oz of household bleach mixed with 1 gallon of
hot water. Wipe the hopper and water proofing rings and blade let stand for at least 3 minutes. Rinse and dry
thoroughly.
Use extreme caution when cleaning the interior of the appliance. Sharp blade can cut and cause injury.