Omcan 31780, Инструкция по эксплуатации

Страница: 8 / 24

8
Installation
ice maker but please give a call to either the seller or Omcan for advice.
• Remove shipping tape which is holding the door and front panel.
• Remove the protective plastic film from the exterior. If the ice maker is exposed to the sun or heat, remove
the film after ice maker cools down.
• Remove the package of accessories, and check the content:
- Inlet water tube.
- Ice shovel.
- Foot base.
- Drain tube.
- Plastic connector.
LOCATION
• This ice maker is not intended for outdoor use. Normal operating ambient temperature should be within
10°C to 43°C, normal operating water temperature should be within 8°C to 32°C, operation of ice maker
for extended periods, outside of these normal temperature ranges, may affect ice production capacity and
performance.
• Ensure that free flow of clean air is available around the ice maker.
• The ice maker should not be located close to the heat source or exposed to the sun.
• Location should provide a firm and level foundation for the ice maker.
• Allow 15cm clearance at rear and sides for proper air circulation and ease of maintenance.
• This ice maker is not suitable for installation in an area where a water jet could be used and where water
dripping is not allowed.
• To prevent damage to the water supply line, please drain the ice maker when ambient temperature is too
low.
LEVEL ADJUSTMENT OF ICE MAKER
• The level adjustment affects the ice size.
WARNING
If the power supply cord is damaged, don’t operate the machine until it is replaced by the authorized service
agent or qualified technician.
CAUTIONS
Please take protective measures when the ambient temperature is below 10°C. Faults due to the ambient
temperature below 10°C are not covered by warranty.
• Place a level measurement at the machine top, adjust the machine base for front & rear, left & right
balance.