Omcan 31780, Инструкция по эксплуатации

Страница: 13 / 24

13
Operation
Maintenance
ICE DROP PROCESSING
Heated refrigerant flows into evaporator which raises the temperature of the evaporator, which causes the ice
drop in storage bin. When evaporator temperature reaches 25°C, the ice drop process will finish and next ice
making cycle will start.
ICE FULL
When Ice bin is full, ice level switch will switch off the ice maker and Ice Full indicator light will be ON.
When the ice level drops, the ice full switch will reset and ice maker will restart.
TO MAKE SURE THE CONTINUOUS RUNNING OF THE ICE MAKER, PLEASE CHECK THE
FOLLOWING STEPS:
• Water supply is connected and faucet is open.
• Ice maker has been connected to the electrical socket and machine switch on.
• Ice making indicator is lighting on.
LONG TERM STORAGE OF ICE MAKER
• Turn control switch to “off’ position.
• Unplug the power cord or power off the machine.
• Turn off the water supply and remove the water inlet pipe.
• Remove all ice out of the storage bin and cleaning the machine.
• Disconnect the silicone hose, to discharge water from water tank. After water drains out, reconnect the
silicone hose to the correct position.
WARNING
• Disconnect electrical power before performing any cleaning or maintenance.
• Inspection and cleaning the condenser should be done only by a qualified service technician; at least once
every year.
• Don’t clean the ice maker by spraying water.
• To prevent cracks to the plastic part of ice maker, do not use any alcohol or disinfecting-type cleaners.
• Do not remove the top cover or the heat partition without authorization. Removal should be performed only
by qualified service technicians.
• Clean the ice maker exterior by wiping with a clean soft cloth, at least once a week. Use damp cloth with
neutral detergent to wipe off grease and dust.
CLEAN AND DISINFECT THE SLIDING DOOR HANDLE OF ICE MAKER AND ICE
SHOVEL (EVERY DAY)