31
This is an example from a
previous attempt at transmitting
when
the
antenna
was
disconnected from the PA .
Reflected power was higher
than 350W and a warning
message “Reflected power too
high” appeared.
If you touch the yellow “last
events” box on the PA touch
screen it will display the warning
details.
In the case of some hardware
failure or if your power amplifier
is not working properly, please
contact the manufacturer or your
local dealer.
Never try to change or move any part inside the amplifier except the tube or
fuses. Substitution of parts may void intrinsic safety!
Manufacturer’s contacts: OM POWER, s.r.o.
930 30 Bá
č
126
SLOVAKIA
Email: [email protected]
6.2.
Fuse Replacement
The user is allowed to change mains fuses (6.3 x 32mm), accessible from the rear panel, only.
In the case of fuse (fuses) interruption inside the power amplifier,
exchange can be carried out
only by professionally qualified persons!
Internal fuses are located mainly on the SWITCH-
on board (next to the HV transformer).
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
