16
You selected IC7800 addr.6AH and 19200
Bd. Press
SET
to write to the memory,
then press
EXIT
to go back to the
SETTINGS possibilities.
“
SET OTHER ADDRESS
” means that you
must add here a new type of ICOM TCVR
which is not defined in the table (its
address plus bitrate in Bd) to allow
communications with it.
Press
ANTENNA SETTINGS
. First select
ANTENNA
SWITCH
(No
switch,
Standard). Use left or right arrows. If you
select some switch, 10 ports for different
antennas displays. Generally all of
antennas are allowed in every band
(green squares). To disable some square
select port (up/down), touch
SET
for
antenna name and then select band
(left/right). Press
SET
.
.
Four types of antennas for four different
bands were disabled.
Black
square
means
disabled
combination.
Press
EXIT
to go back to
SETTINGS
menu
BCD code (4 bits) is used for automatic antenna and BPF switching (see Antenna/BPF
connector on the Control panel (rear side of the PA). See section 7.9 for Control and ANT/BPF
connectors pin-out.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Содержание OM2000A+
Страница 39: ...39 Connection setting Set up TCP IP address and port Connect disconnect to OM2000A...
Страница 49: ...49 7 7 ICOM connection with OM2000A...
Страница 50: ...50 7 8 Yaesu plus BPF plus ANT Switch connection with OM2000A...
Страница 55: ...55 7 10 Block Diagram of the OM2000A Power Amplifier...
