E-11
En
2)Connecting the hot shoe cable
Connect the hot shoe cable, provided with this case, between the TTL cable connector on
the inner side of the camera case and the hot shoe of the camera. Pay attention to the
following points:
Before inserting the camera into the camera case, loosen and remove the cap on the TTL
cable connector inside the camera case;
Insert the 5-pin connector of the hot shoe cable into the TTL cable connector inside
the camera case;
Turn the lock dial screw on the hot shoe cable
'
s connector all the way clockwise to lock
the connector firmly;
Insert the camera in the camera case;
After inserting the camera, insert the hot shoe unit of the hot shoe cable all the way into the
camera's hot shoe.
The hot show cable can be disconnected by reversing the connection steps. In the final
step, screw the cap back onto the TTL cable connector inside the camera case until it
stops.
MENU
MENU
MENU
Protective
cap
Lock dial screw
：
• Pay attention to the position of the 5 pins when connecting the connectors.
• When screwing in the lock dial screw for clamping the hot shoe connector,
place the Case upside down. Be careful not to drop the Case.
• Do not use excessive force when tightening the lock dial screw on the
cable’s connector.
• When the hot shoe cable is not connected, be sure to put the caps back on
the TTL cable connectors.
CAUTION
PFL̲E01̲E 2005.5.25 4:36 PM ページ11
