E-16
En
Check the loading status.
Always perform the following final checks before sealing the Case.
･
Is the electronic flash attached firmly to the hot shoe of the Case?
･
Is the silica gel inserted all the way at the specified position?
･
Is the O-ring installed properly?
･
Are the O-ring and the O-ring contact surface free of dirt and other foreign matter?
Seal the Case.
Close the rear lid (gently, so that the O-ring
will not come out of the groove), engage the
buckles with the hooks on the rear lid, and
push the buckle lock/unlock levers down in
the direction of the arrows. The Case will be
sealed airtight.
Perform the final checks.
Visual inspection
After sealing the Case, visually examine the sealed sections on the front and rear lids to
confirm that the O-ring is not twisted or out of the groove and that no foreign matter has
been caught.
Switching the electronic flash on
Press the power button and confirm that the electronic flash power is switched ON/OFF.
Turn the select dial and confirm that the electronic flash mode dial is set to the TTL AUTO
or MANUAL position.
：
• Seal the Case by pushing all three buckle lock/unlock levers down in the
direction of the arrows.
• If one of the buckles is left open, the Case will not be sealed properly and
water leaks will occur.
CAUTION
：
• Hairs, fibers and other small items are not easy to see, but they may allow
water to get inside, so that special attention is required.
CAUTION
：
• After loading the electronic flash in the Case, confirm that the select dial is
rotatable. If not, there may be oil or grease on the dial knob. Wipe it off
completely.
CAUTION
PFL̲E01̲E 2005.5.25 4:36 PM ページ16
