Olympus OEV261H, Инструкция по эксплуатации, Страница: 30 / 105

26
Chapter 4 Inspection and Setup Before Use
High definition LCD monitor OEV261H
Chapter 4 Inspection and Setup Before
Use
Before using the monitor, be sure to inspect and set it up as
described in this chapter. Also inspect the ancillary
equipment to be used in combination with this monitor as
described in the instruction manuals for the equipment. If any
irregularity is suspected with the monitor, do not use it and
take remedial actions as described in Chapter 10,
“Troubleshooting”. If this cannot restore the normal
operation, contact Olympus. Using the LCD monitor
(OEV261H) while an irregularity is suspected does not only
result in malfunction but may also cause an electric shock,
injury and/or fire.
Inspect the monitor and ancillary equipment according to the purpose of use by
referring to the “System chart” in Appendix. For the inspection, observe the
following sections and also refer to the instruction manuals for the ancillary
equipment.
4.1 Power supply
Inspecting the power supply
Confirm that the monitor can be turned On as described on Section 2.2, “Front
panel” on page 15 and Section 2.4, “AC adapter” on page 19. The POWER LED
should light up in green.
When the monitor does not power On, check the equipment as follows;
• Confirm that the power cord and DC cord are connected as described in
the instructions Section 3.3, “Connection to an AC mains power supply”
on page 24.