Olympus OEV261H, Инструкция по эксплуатации, Страница: 11 / 105

Important Information — Please Read Before Use
7
High definition LCD monitor OEV261H
−
In case of a loss of the endoscopic image or a frozen
image:
Turn off the monitor, and turn on it again after 10 seconds.
Also turn off the ancillary equipment to be used in
combination with this monitor and turn on it again, as
described in the instruction manuals for the equipment. If
the problem cannot be resolved by the described remedial
action, stop using the monitor and gently withdraw the
videoscope, fiberscope, rigid endoscope or ultrasonic
endoscope from the patient’s body as indicated in the
endoscope’s instruction manual.
−
In case other abnormalities:
Immediately stop operation of the monitor, withdraw the
videoscope, fiberscope, rigid endoscope or ultrasonic
endoscope from the patient as indicated in the
endoscope’s manual, and take remedial action as
described in Chapter 10, “Troubleshooting”. If the problem
cannot be resolved by the described remedial action, be
sure to contact Olympus for repair as described in Section
10.2, “Returning the monitor for repair” on page 83.
• When installing this instrument on the mobile workstation or a
trolley with a clamping table, be sure to provide the mobile
workstation or trolley with a toppling/movement prevention
measure. If such a measure is not taken, the mobile
workstation or trolley could move or fall during the procedure,
which could cause patient and/or operator injury.
• Before using high-frequency electrosurgical equipment,
make sure that any signal noise emitted from the equipment
does not affect the observation of the surgical procedures. If
high-frequency electrosurgical equipment is used without
such confirmation, patient injury may result.
• To prepare for unexpected equipment failure, be sure to
prepare spare equipment.
• It is recommended that only Olympus high-frequency
electrosurgical equipment be used with this unit.
Non-Olympus equipment can cause interference on the
monitor display or a loss of the endoscopic image.
• Always establish the system with equipment that complies
with relevant EMC standards for safety reasons. Equipment
which does not comply with EMC standards may cause
interference and its function or performance may be affected.