22.
Locate an
Angled Wall Extendor
and T
op Siding Piece for Angled Wall Extendor (L/R)
.
Position top siding on wall extendor and align as shown above. Attach with
3 - 1 1/2” Finishing Nails
to
top wall framing. There are left/right top siding pieces. Use rough surface side out.
Place finished wall extendor on side wall panel frame. Complete both sides now.
Note:
Bottom siding of wall extendor will overhang and cover siding of side wall.
5 1/2”
5 1/2”
20.
Position Door Jambs flush against narrow and window wall studs and tight to floor. The Jamb is
3 1/2” wide and will sit flush to outside of wall siding. When positioned correctly, secure Jambs using
4 - 2 1/2” Screws
.
21.
Position and attach the
Door Header
to top of Narrow Wall framing and against window wall framing
resting on top of door jambs. Header should sit flush on Door Jambs. Attach with
4 - 2 1/2” Screws
. On
window side, screw about 1” from end of header at angle into window wall framing. Pilot hole first.
Dado cut on edge.
Jamb flush with
siding butt.
Jamb flush with
top of narrow wall.
Gap on window side.
Angle Pilot
Hole first.
Side W
all Panel
Front Window W
all Panel
Top Siding Pc.
Top Siding Pc. for Angle Wall can also be
installed after Roof is attached after Step 46.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 13
