20.
Position Door Jambs flush against narrow and window wall studs and tight to floor. The Jamb is 3
1/2” wide and will sit flush to outside of wall siding. When positioned correctly, secure Jambs using
4 - 2 1/2” screws. With both door jambs secured, confirm 32” door opening.
21.
Position and attach the
Door Header
to top of Narrow Wall framing and against window wall framing
resting on top of door jambs. Header should sit flush on Door Jambs. Attach with 4 - 2 1/2” screws. On
window side, screw about 1” from end of header at angle into window wall framing. Pilot hole first.
Dado cut on edge.
Jamb flush with
siding butt.
Jamb flush with
top of narrow wall.
Gap on window side.
Angle Pilot
Hole first.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 13
Door opening
should be 32”
Top Siding Pc. for Angle Wall
will be installed after Roof is
attached in Step 43.
Top Siding Pc.
Side Wall Panel
22.
Locate both
Angled Wall Extenders (L/R)
. Place first wall extender on side wall panel frame.
Note:
Bottom siding of wall extender will overhang and cover siding of side wall.
