Olsen Flex Quality, Руководство по эксплуатации

Страница: 14 / 56

14
6.3.2 - Brushless Electrical Micromotor - Built in (Optional)
Before starting the
operation, connect the handpiece to
the electrical micromotor (8).
To activate the rotation: press the
propulsion/activation pedal (7).
To select the transmission: use the Select key (5). The
selection is indicated by LED’s ( 3): 20: 1; 1: 1 and 1: 5.
To reverse the rotation: use the Reverse key (1).
To adjust speed: use the adjustment key (4) The speed relation of each transmission with the value of the
display (2) is indicated in the side table.
Example:
Display value: 15
Selected gear ratio: 1:1
Factor: x1.000
Rotation speed: 15 x 1000 = 15.000 rpm
To activate memory: press the desired Memory key (6). The display will show the speed and the LED will
indicate the present transmission.
To record memory: select the transmission and adjust the speed of rotation to store. Press and hold one
of the Memory key (6) until the system emits 2 beeps, indicating that the memory has been recorded.
To save the second available memory repeat the same procedure.
To adjust the electrical micromotor water: use the water control knob (9) on the instruments control
panel.
6.3.3 - Brushless Electrical Micromotor - Side Panel (Optional)
Before starting the operation, connect the
handpiece to the electrical micromotor (16).
To activate the rotation: press the
propulsion/activation pedal (14) or the Manual
Start key (11).
To select a preset program: use the Program
key (8). There is 7 programs available, according
the table below:
The selected program is shown on the display (1).
To record program: select program P1 or P2, then select the desired
gear ration and adjust the speed. Press and hold the Program key (8) until the confirmation of the system.