Olivetti IC-420, Руководство по обслуживанию, Страница: 43 / 61

41 Service Guide
Installing System Software
13
Reconnect the cables to the Fiery ES (see Figure 8 on page 24):
•
Connect the network cable between the Fiery ES and the customer network.
• Connect the crossover Ethernet cable between the Fiery ES and the printer.
• Connect the printer interface cable between the Fiery ES and the Printer.
14
Press the power button once to start the Fiery ES.
Allow the Fiery ES to start up and reach Idle (
00
should appear on the Fiery ES LED display).
15
Power on the printer using the main power switch.
Wait approximately 15 minutes for the Fiery ES Start page to print.
16
If you saved a configuration file earlier, restore the system configuration (see page 34 ).
Note:
If it was not possible to save a configuration file or if you installed an upgraded version of system software, you
must configure Setup using the Configuration pages you printed earlier. For information about performing Setup, see
Configuration and Setup, which is part of the user documentation set. Bypass any settings if it is more appropriate for
the site administrator to set them. After you exit Setup and allow the system to reboot, ask the site administrator to
restore the custom files that were archived earlier.
17
Install any required software patches:
• If you reinstalled the same version of system software, be sure to reinstall all software patches that were previously
installed on the Fiery ES. For a list of installed patches, see the Configuration pages that you printed earlier.
•
If you installed an upgraded version of system software (for example, version 1.0 to version 2.0), contact your
authorized service/support center for a list of valid software patches. Some or all of the patches listed on the
Configuration pages that you printed earlier may no longer be valid. Before installing a patch, be sure to verify with
your authorized service/support center that it is valid for your system version. Installing an invalid patch may result
in system corruption.
18
Reconnect any USB devices that you may have removed earlier.
Printing the Configuration pages
This section describes how to print the Configuration pages. The Configuration pages list all installed options on the Fiery
ES, as well as the customer’s current Setup configuration (for more information, see
page 32 ).
To print the Configuration pages
1
If necessary, press the Menu button on the printer panel and select Fiery.
2
Press the icon on the lower left corner of the printer control panel, and select Print Pages.
3
From the Print Pages screen, select Configuration.
Wait for the Configuration pages to print.
Y119660-9 Service Guide