Oliver 4680, Руководство пользователя

Страница: 14 / 30

15
Check power wire connection
After the power source wires have been connected, check if the power wires are connected to the correct
points or not. This can be identified by checking the running direction of the conveyor. If the conveyor
belt runs to the connect direction, this means the power wires are connected to the correct points.
Otherwise you should change any two of the three power wires.
Installing the saw blade
1. Disconnet the resaw from the power source.
2. Press the saw blade tension button “off”. (please note that if lower saw blade lower than 40mm, the
button can not be changed to “off”. Prevent saw wheel from hitting conveyor table.)
3. Put on protective gloves.
4. open the wheel covers for access to the wheels.
5. Hold the blade from each side, and position it in front of the wheels so the blade teeth are facing the
front of the machine.
6. Carefully fit the blade over each wheel and position it between the blade guides. Make sure the teeth
point toward the right-hand side of the machine, as you are facing the front.
7. Position the blade on the wheels so the tooth gullet is approximated 1/16” over the edge of the wheel.
8. Slide the upper guide block up, place a dollar bill (as a quick gauge for 0.004" clearance) underneath
the upper guide block, then let the upper guide block slide down to sandwich the dollar between the
blade and the upper guide.