Olimpia splendid ELLISSE HP, Руководство пользователя

Страница: 6 / 15

7 DEHUMIDIFICATION MODE
This mode can be selected by pressing B2 or SW2 until the dehumidification symbol
(only) is shown on both the remote control’s and L1 display. This mode works
similarly to cooling mode except for:
•
internal fan speed selection, which is forced to run at minimum speed (B6, B7 and SW3 are
disabled, no fan symbols are shown on both the displays), except during defrosting subprogram,
see below for further details;
Min FAN
Med FAN (during defrosting
only)
DEHUMI MODE 920 r/min ±5% 1100 r/min ±5%
•
Tset which is set equal to the Troom (room temperature) every time thefunction is enabled and
just before first compressor activation (it cannot subsequently be changed, B4/B5 and SW4/SW5
are disabled, Tset values on both the remote controller and the display unit are replaced by
‘ ‘ );
•
Compressor working cycle which is controlled as follows:
o
ON continuously for Troom > Tset+2°C
o
6 minutes ON and 6 minutes OFF for Tset-2°C<Troom
≤
Tset+2°C
o
6 minutes ON and 12 minutes OFF for Tset-4°C<Troom
≤
Tset-2°C
o
OFF continuously for Troom
≤
Tset-4°C
Note: After each dehumi mode start, the compressor always waits 3 minutes before its first activation.
Regardless of Troom and Tset acquired, compressor always runs a 6minON/6minOFF cycle first.
In this status the defrosting subprogram is still enabled, and all appliance’s malfunctions can be signaled.
When defrosting function is active in dehumidification mode, the int fan must always be forced to MED
speed.
8 HEATING MODE
This mode can be selected by pressing B2 or SW2 until the heating symbol (only) is shown on both the
remote control’s and L1 display. In heating mode the water disposal motor must always remain switched
OFF.
The temperature set-point (Tset) can be adjusted from 16°C to 27°C in 1°C steps
Tset+1°C
Tset-2°C
Tset-4°C
on
6min 12min
Tset+2°C