User Manual LR-16F
OMEN-16F-202012
17
The web page setting interface and the upper computer software interface may change
due to continuous updated products, and the actual content shall prevail.
9.2.
Configuration software
The configuration software 3D Lidar config Ver1.0.2 is mainly used to modify and
configure the basic parameters of 16-line lidar. The software interface is as shown below
Lidar Ip: Lidar IP;
Lidar Port: Lidar Port;
Remote Ip: host IP;
Remote Port: host port;
Motor RPM: Lidar rotating speed, optional 300/600;
GPS Enable: GPS port, select Disable if there’s no GPS.
Instructions:
1.Connect the lidar according to the correct method to make the communication normal;
2.Click Connect. After the data on the left side of the figure below is normal, click Modify to
modify the corresponding parameters as needed;
3.Restart lidar to make parameters effective.
4.When in the Connect state, in the right-click menu of the Lidar Info area, you can choose to
reset the Lidar IP configuration to factory defaults.
