Oldham MX62, Руководство пользователя

Страница: 39 / 74

Page 39
4.2.7. Analog outputs
The respective analog output is selected by the arrow buttons. For
selection, only configured analog outputs are taken into consideration and
displayed. After selection of an analog output, its configuration and actual
value are indicated.
4.2.8. Datalogger / Set-up
After selection of the respective channel, data recording for this channel
can be configured.
The modes 8-hour mean value as well as Recording can be activated or
deactivated. With Recording being activated, the Recording mode may
also be set.
With continuous recording, the measured values of the selected channel
are constantly stored.
With event recording, only events of the respective channel are recorded.

Modifications for recording of a channel can only be effected if the
rotary switch on the controller module is not in position 5 (PC
communication).
4.2.9. Datalogger / Histogram
After selecting the respective channel by the arrow buttons, the histogram
of the channel is displayed.
By means of this histogram, gas concentrations can be monitored over a
longer period of time.
To see the concentration prevalent at a certain time, a cross is moved to
the respective position with the aid of the arrow buttons. This cross is
found on the X-axis. The gas concentration measured as well as any active
alarm signal at the time is shown in the upper margin of the LCD.
By operating the button OK , the histogram can be deleted.
Recording intervals may be set in the menu Datalogger of the
configuration software ConfigPro .
4.2.10. Datalogger / Events
At first, general information on events is shown such as number of all
events from beginning of the recording, start of recording, date of latest
event, etc.
In addition, a menu is displayed for selecting the next step: