Oldham MX62, Руководство пользователя

Страница: 21 / 74

Page 21
minimum one channel is still deactivated, this relay will operate and the
user is informed that not all channels are activated.

The alarm suppression and deactivation of a channel have effect on
the activation of the general buzzer relay.

The general buzzer relay will not be activated if a deactivated or an
alarm suspended channel is triggered by an alarm.
3.2. Sytem start-up
Upon start-up or directly after voltage cut-off, alarm signals are blocked for 1 to
10 minutes (setting by software
ConfigPro ). After the start-up mode, the system
automatically enters into the operating status.

As many detectors signal undefined values after start-up, this mode
eliminates any false alarms.
During start-up the LEDs for system information can be checked. All four
system LEDs are switched on for 0.5 s and those of the LED modules for 2 s.
The display of the LCD module is built up line by line.
Display, messages, outputs:
LED module: LED Power and LED Fault are flashing
System: LED Service is flashing, relay Service is activated
RBM/REM: no relay is activated
AAM: 2 mA
LCD module: display initialization and start-up messages
Printer: message: Cold reset , software version
If a mean value is configured for a given channel, the calculation for the mean
values starts new after re-entering the normal operation mode.
3.3. Normal Operation
The system automatically enters into normal operation once power has been
supplied and the system has finished the start-up mode (see chapter 3.2).
During normal operation, both controllers of the CM carry out redundant
measurement. Every channel that has been switched on will, depending on the
measured value, enter into one of several possible states. The relevant green
LED
Power on the LED module will signal if a channel is switched on. This
LED will start blinking as soon as the respective channel is shown on the LCD
display.