Okuma OSP 5000, Электротехническое обслуживание, Учебное пособие

Страница: 50 / 286

4-1
Okuma America Corporation
MACHINE OPERA MACHINE OPERA
MACHINE OPERA MACHINE OPERA
MACHINE OPERATION TION
TION TION
TION
Rev. 8-21-01
The OSP 5000 series family has been around since 1981. In 1985 Okuma incorporated the
graphics function into the 5000 series control. In 1988 Okuma introduced the OSP 5020 series
control whose speed and accuracy was dramatically increased. The newly developed high-
precision digital servo technology and 32-bit double-engine architecture increased the machines’
cutting feedrate from 1.25 m/min to 15 m/min. The following is a chart of the OSP 5000 series
controls. For the rest of this manual, if the specific control type is not mentioned, the topic
being discussed refers to all these controls.
Basic Construction of the Operation Panels
Okuma machine tools with the OSP 5000 series controls mainly consist of four panels.
1. NC Operation Panel (Common Panel)
2. Machine Operation Panel
3. Pendant Operation Panel
4. Option Panel
NC Operation Panel
The NC operation panel is common on all Okuma machines. The 5000 series controls are
equipped with a 12-inch CRT. The 500 series controls are equipped with a 9-inch CRT. A
picture of a 5020M and a 5020L NC operation panel can be seen on page 4-31 and 4-33 respec-
tively. The following is a description of the OSP 5000 series NC operation panel.
This control has eight function keys located below the CRT. These function keys are used to
access the different menus on the control. Each mode key has a different set of menus. Depend-
ing on which mode the control is in, the function keys will help the user to access the menus
associated with these individual modes.
OSP 5000 Family OSP 5020 OSP 5020L
OSP 5020M
OSP 5020G
OSP 5000 OSP 5000L-G
OSP 5000M-G
OSP 5000G-G
OSP 5000N
OSP 5000L
OSP 5000M
OSP 5000G
OSP 500 OSP 500L
OSP 500M
OSP 500G
OSP 5 OSP 5