Oki OKIFAX 5700, Руководство по обслуживанию

Страница: 349 / 472

SIGNAL FLOW
OKIFAX 5700/5900 A2 - 18
A2.2 Explanation of Signal Flowchart
(1) Copy Mode
The analog data output from the image sensor is input to the MCNT-PCB to be ampli-
fied by the amplifier. The amplified analog data is input to the scanner controller.
Next, the analog data is converted to digital data by the built-in A/D converter. The
digital data is corrected by the internal correction function, transferring binary-coded
data to the IOGA5 every eighth pixel. The data input to the IOGA5 is temporarily
written into the external DRAM (4 megabits x 16 bits). The written data is sent, through
the IOGA5, to the LED head in sync with the print operation.
(2) G3 Send Mode (MH/MR/MMMR Codes)
The analog data output from the image sensor is input to the MCNT-PCB to be ampli-
fied by the amplifier. The amplified analog data is input to the scanner controller.
Next, the analog data is converted to digital data by the built-in A/D converter. The
digital data is corrected by the internal correction function, transferring binary-coded
data to the IOGA5 every eighth pixel. The data input to the IOGA5 is temporarily
written into the external DRAM (4 megabits x 16 bits). The written data is converted to
MH/MR/MMR codes by firmware, then written into the external DRAM again.
The converted data is sent to the modem board to be modulated. The data modulated
by the modem is sent to the NCU board by the Send signal “S.” The data sent to the
NCU board is amplified there, then output to the public line.
(3) G3 Receive Mode (MH/MR/MMR Codes)
The signal input from the public line to the NCU board is amplified, input to the modem
board as an R signal, demodulated by the modem, and written into the DRAM on the
MCNT PCB.
MH/MR/MMR-code data is converted to image data by firmware and written into the
DRAM again. The written data is sent, through the IOGA5, to the LED head in sync
with the print operation.
(4) G3 Receive Mode (JBIG Code)
The signal input from the public line to the NCU board is amplified, input to the modem
board as an R signal, demodulated by the modem, and written into the DRAM on the
MCNT PCB.
JBIG-code data is sent to the JBIG control LSI chip to be converted to image data.
Then, the image data is written into the DRAM.
The written data is sent, through the IOGA5, to the LED head in sync with the print
operation.
(5) G3 Send Mode (JBIG Code)
The analog data output from the image sensor is input to the MCNT-PCB to be ampli-
fied by the amplifier. The amplified analog data is input to the scanner controller.
Next, the analog data is converted to digital data by the built-in A/D converter. The
digital data is corrected by the internal correction function, transferring binary-coded
data to the IOGA5 every eighth pixel. The data input to the IOGA5 is temporarily
written into the external DRAM (4 megabits x 16 bits). The written data is converted to
MH/MR/MM codes by firmware, then written into the external DRAM again.
The converted data is sent to the JBIG control LSI chip to be converted to JBIG codes.
Next, the JBIG-code data is sent to the modem board to be modulated. The data
modulated by the modem is sent to the NCU board by the Send signal “S.” The data
sent to the NCU board is amplified there, then output to the public line.