Configuration ID
The two configuration IDs are used to communicate information about certain areas of
the printer that cannot be determined using hardware sensors. The configuration IDs are
originally set at the factory when the printer is manufactured, however, the technician
may need to reset Configuration ID 1 or Configuration ID 2 whenever you replace the
system board. The IDs consist of eight hexadecimal characters, including 0 through 9 and
A through F.
Note:
When the printer detects a Configuration ID that is not defined or invalid, the
following occurs:
•
The default standard model Configuration ID is used instead.
•
Configuration ID is the only function available in DIAGNOSTICS.
•
Unless the menu is in DIAGNOSTICS,
Check Config ID
displays.
To set the configuration ID:
•
Select
PRINTER SETUP
from the
Diagnostics
Menu.
•
Select
Configuration ID
.
•
Select the keyboard icon to display a keyboard with 1 through 0 and a through f.
The current values for Configuration ID 1 and Configuration ID 2 are displayed.
1.
Use keys to type the numbers for the two configuration IDs.
2.
Use the left arrow to move over a digit from the right of the number
toward the left.
3.
When the numbers are correct, touch
Submit
.
4.
If you have a question, touch the question mark icon.
5.
To exit without changing the numbers, touch
Back
.
Note:
Be sure to touch Submit, or the number will not be changed.
Submitting Selection
displays, followed by the value for Configuration ID 1.
Note:
If
Invalid ID
appears, the entry is discarded, and the previous
Configuration ID 1 is displayed on the screen.
If the process is successful,
Submitting Selection
appears on the display, followed
by the current value for Configuration ID 2.
To save all changes, RESTART THE PRINTER.
Edge to Edge
When this setting is
“On”
, the text and graphics are shifted to the physical edges of the
paper for all margins. When the setting is
“Off”
, the normal margins are restored.
Enable Edge to Edge Copy
The settings are ON and OFF.
24
