Oilon KP-6, Инструкция по эксплуатации и техническому обслуживанию

Страница: 9 / 37

7
20039847GB
4. Burner Installation
4.1. Burner Mounting
The furnace, which has a flame-shaped design, does not require refractory. Boilers without
bottom cooling require refractory to prevent heat from reaching boiler foundations.
The flame must at no point come into contact with the furnace walls. If this cannot be avoided,
such points must be covered with refractory. This applies especially to the refractory at the back
wall of short furnaces.
1 Mounting plate
2 Gasket
3 Thermal insulation
BURNER Ø D2
KP-6, -6 L, -6 LH 95
KP-6-2, -6 H-2 105
The mounting plate must have either two or four M10 threaded holes for the mounting of the
burner according to the drawing.
4.2. Hinged Burner Housing
On standard version the burners are delivered to be hinged to both sides.
4.3. Electric Connections
The burner must be connected according to the electrical diagrams delivered together with the
burner. General and local standards and regulations as well as requirements of electrical
equipment on electrical connections must be adhered to.