Oilon KP-6, Инструкция по эксплуатации и техническому обслуживанию

Страница: 4 / 37

2
20039847GB
2. General
Oilon KP-6...KP-6 H-2 burners are fully automatic light oil burners.
These burners can be used on most heating appliances such as hot water boilers, steam boilers
and air heaters.
A fan attached to the burner and dimensioned to provide a sufficiently high and even air
pressure for efficient combustion in modern combustion chambers delivers the required air.
The burners are suitable for use on light fuel oil with a viscosity of 4 - 12 mm²/s (cSt) at a
temperature of +20 °C.
The oil coming to the burner must be filtered before the burner oil pump. Filtration degree may
be max. 100
µ
m.
Oil atomising pressure: • 1-stage burners 700 - 1400 kPa (7 - 14 bar)
• 2-stage burners 700 - 2500 kPa (7 - 25 bar).
The ”H” burners are high-low -burners and ”LH” burners are equipped with a preheater.
2-stage burners (”H” burners) have a maximum control range from 55 to 100 %.
Required combustion air quantity: 15 m³ for each kg of oil to be burned.
Burner operation is automatically controlled and supervised by the control unit.
Boiler thermostats or pressurestats controls the burner capacity.
Protection: IP20
Supply/control voltage 230 V (-15 %...+10 %), 50 Hz, 1-phase
Input power: 260 W 1,13 A (KP-6, KP-6-2, KP-6 H-2)
500 W 2,2 A (KP-6 L, KP-6 LH)
The ambient temperature during burner operation must be 0...+40
°
C.
The following should be checked before first start-up:
● connections are correct,
● settings of regulating and control devices are correct,
● boiler and its equipment is in working condition,
● boiler room is adequately ventilated,
● valves in supply line are open,
● there is oil in the tank,
● oil temperature is adequate in such a way, that the oil viscosity is 4 - 12 mm²/s
(max. +60
°
C).