Oilon Junior Pro 1 J10, Инструкция по эксплуатации и техническому обслуживанию

Страница: 6 / 44

2
10090943EN
2. General
Oilon Junior Pro burners are fully automatic light oil burners.
The burners can be used on most heating appliances such as hot water boilers, steam boilers
and air heaters.
A fan attached to the burner and dimensioned to provide a sufficiently high and even air
pressure for efficient combustion in modern combustion chambers supplies the required air.
The burners are suitable for use on fuel oil (light fuel oil), with a viscosity of 4 - 6 mm²/s (cSt) at
a temperature of +20 °C.
The oil supplied to the burner must be filtered before the burner oil pump. Filtration degree is
from 20 - 40
μ
m. We recommend mounting of an Oilon Plus filter and deaerator unit.
Oil atomizing pressure 800 - 1400 kPa (8 - 14 bar). Factory setting approx. 10 bar.
”LJ” burners are equipped with a preheater.
Required combustion air quantity: 15 m³ combustion air for each burnt kg of oil.
Burner operation is controlled and monitored by the burner automation.
Boiler thermostats or pressurestats control the burner capacity.
Burner protection: IP20
Supply voltage 230 V (-15 %...+10 %) 50 Hz 1-phase
Consumption: approx. 135 W, 0,71 A, 230 VAC, 50 Hz, 1-phase (J10, J18, J20, J45, J50)
approx. 220 W, 1,0 A, 230 VAC, 50 Hz, 1-phase (LJ10, LJ18)
approx. 330 W, 1,7 A, 230 VAC, 50 Hz, 1-phase (LJ20, LJ45, LJ50)
The ambient temperature during burner operation must be +8...+40
°
C.
The following should be checked before first start-up:
•
connections are correct
•
settings of boiler regulating and control devices are correct
•
boiler and its equipment are in working condition
•
boiler room is adequately ventilated
•
valves in supply lines are open
•
there is oil in the tank
•
oil temperature is adequate so that the viscosity is 4 - 6 mm²/s (max. +60
°
C).