01/04/2021
Page 4
3.3.
ENGINE START mod. 110 AUTOMATIC
To start the cold engine:
•
Open the fuel taps of the tank and of the carburetor by rotating the command counter clockwise.
•
Activate the choke control and hold it in position (follow the direction of the arrow in the photo).
•
Set the engine kill command in ON position.
•
Pull the rear brake. (hand master cylinder on the left half-handlebar).
•
Push the starter button.
•
Deactivate the choke command with the engine running and let it run at minimum rotation speed for a few
minutes to warm it up.
Info
Do not use the choke command to start up the engine when it’s hot.
Info
Do not use the throttle during start-up to avoid problems with kickback of the start lever and backfires
inside the carburetor.
3.4.
ENGINE START with KICK STARTER
To start the cold engine:
•
Open the fuel tap by rotating the command counter clockwise.
•
Activate the choke command and hold it in position as previously indicated.
•
Set the shift in neutral.
•
Set the engine kill command in ON position.
•
Push the kick starter lever until the TDC* piston position (the effort increases).
* TDC = Top Dead Centre
•
Keep the lever pressed and when the effort begins to decrease, push the lever quickly and vigorously throughout its
stroke.
•
Deactivate the choke command with the engine running and let it run at idle speed for a few minutes to warm it up.
Info
Do not use the choke command to start up the engine when it’s hot.
Info
Do not use the throttle during start-up to avoid problems with kickback of the start lever and backfires
inside the carburetor.
Pay attention to the return of the starting lever. If the lever does not return to its initial
position turn off the engine.
NOTE
If the engine does not start after 10 attempts, wait a few minutes and try again by
deactivating the choke command.
NOTE
For correct engine start-up and operation, check that the minimum rotation speed is
approximately 2000 rpm.
NOTE
For correct engine start-up and operation, check that the minimum rotation speed is
approximately 2000 rpm.
NOTE
If the engine doesn
’
t start in 5 seconds, release the start button and wait 10 seconds
before trying again.
