－
11
－
◆
Adjustment and Check of the timer
he speed of screw delivery depends on the actual kind of screw. By adjust-
ing the timer of the machine the screws are picked up smoothly.
* If a screw is picked up on the stopper and the screw coming next is not
picked up for a certain amount of time, the unit stops the operation. Then if
you pick up the screw, it starts operating again. You can change the time by
adjusting the timer within 1 to 6 seconds.
* Time changes after adjusting the times setting volume on the rear of the
machine as shown on the right. Viewing the unit from the back, if it’s turned
clockwise, the time becomes longer, and if it’s turned counterclockwise, the
time becomes shorter.
* Do not use excessive force while making an adjustment. Turn it only as
much as the possible rotating range allows.
◆
The operation check of the overload protection circuit
For overload detection and check of protection circuits:
Try to force the movement of the scooping block to stop, to check the opera-
tion of overload detection and overload protection circuits.
If you force the movement of the scooping block to stop for about 4.5 sec-
onds or less, the main motor stops after repeating rotations of
reverse -> forward -> reverse -> ....
To cancel the above operational check, turn off and then turn on the power
switch again.
Caution : Use the screwdriver provided with the machine.
Using other screwdrivers may damage circuit components.
Timer setting volume.
Use the provided
screwdriver.
Check overload detection and protection
circuits by forcing the up-and-down
movement of the scooping block to stop.
To increase
time
To reduce
time
