OHAUS Adventurer Pro Grain, Инструкция по эксплуатации

Страница: 12 / 38

Adventurer Pro Grain Test Scale
EN-10
3.4 Using the Button Control Functions
3.4.1 Setting the Scale to Zero
Remove the load from the pan and press the ON O/T button to set the display to zero.
The Center of Zero indicator turns on when the measurement is 1/4 d of the zero
setting.
3.4.2 Taring
Taring refers to the action of adjusting out the weight of a container so that only the weight of
objects held in the container (net weight) is displayed.
To Tare
Place the empty container on the pan and press the
ON O/T button.
Add material to the container. The net weight of the material is displayed.
To clear the Tare value, remove the container from the pan and press the
ON O/T button.
Preset Tare
Use the xT command in the command table to enter a preset tare value through a computer.
To clear the Tare value, enter a value of 0.0. See Section 5.4.1.
3.4.3 Changing Units of Measure
The Adventurer Pro Grain Test Scale can be configured to measure in a variety of units, including
custom units. The Unit Sub-menu is used to enable or disable a specific unit.
To select a unit of measure:
Momentarily press the
UNIT button, then release it when the desired unit is displayed.
Note : If the desired unit is not displayed, it must be turned on in the Unit menu (See Section
3.7.6).
3.4.4 Printing Data
Press and hold the
Print
button to send the displayed value to the COM port (See Section
3.7.7).
Note : The port must have Auto Print set to OFF.
5 page 9 to 15.pmd 7/27/2006, 3:11 PM 10