OHAUS 7000 Series, Инструкция по эксплуатации, Страница: 79 / 134

7000 SERIES INDICATORS EN 73
This template can be edited, as described in the Communication section of Chapter 3 of this manual, Configuration
> Communication > Templates.
Report Format
The Target Table Report can be configured as narrow (40 characters) or wide (80 characters) in setup at
Communication > Reports.
Figure 4-11 details the structure and contents of the Target Table Report in narrow format. Figure 4-12 shows the
same information for the wide format report.
The printed examples show only the format for the Target Deviation tolerance type.
-- TARGET TABLE REPORT --
12:27:43 26 Jan 2012
L5-5 L5 Stake 5Pk
26.56 lb (-) 0.22 (+) 2.36
12 318.42
***************************************
L7-5 L7 Stake 5Pk
35.70 lb (-) 0.53 (+) 3.50
8 285.63
***************************************
S7-8 L7 Stake 8Pk
34.66 lb (-) 0.48 (+) 3.26
18 623.88
***************************************
Figure 4-11: Example of Checkweighing Printed Report, Narrow Format
-- TARGET TABLE REPORT --
12:27:43 26 Feb 2012
L5-5 L5 Stake 5Pk 26.56 lb (-) 0.22 (+) 2.36 12 318.42
******************************************************************************************************
L7-5 L7 Stake 5Pk 35.70 lb (-) 0.53 (+) 3.50 8 285.63
******************************************************************************************************
S7-8 L7 Stake 8Pk 34.66 lb (-) 0.48 (+) 3.26 18 623.88
******************************************************************************************************
Figure 4-12: Example of Checkweighing Printed Report, Wide Format
4.4 Counting
4.4.1 Overview
The T72XW Counting application provides a simple counting sequence that guides an operator through a sampling
process to determine a count value. The counting application offers the following capabilities:

Operator prompting.

Variable sample entry using the terminal’s numeric keypad.

Average piece weight (APW) entry using the numeric keypad.

Up to 99 stored ID records in the ID Table

Count accumulation by ID.
When the FUNCTION key is pressed from the basic weigh mode the initial Counting display screen will be
shown. The icon in the lower left corner indicates the Counting application mode. Pressing the FUNCTION
key again will return the terminal to display the basic weighing mode.